qemu/docs/specs/virt-ctlr.txt
Laurent Vivier 0791bc02b8 m68k: add a system controller
Add a system controller for the m68k-virt machine.
This controller allows the kernel to power off or reset the machine.

Signed-off-by: Laurent Vivier <laurent@vivier.eu>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Tested-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Message-Id: <20210312214145.2936082-5-laurent@vivier.eu>
2021-03-15 21:02:57 +01:00

27 lines
957 B
Plaintext

Virtual System Controller
=========================
This device is a simple interface defined for the pure virtual machine with no
hardware reference implementation to allow the guest kernel to send command
to the host hypervisor.
The specification can evolve, the current state is defined as below.
This is a MMIO mapped device using 256 bytes.
Two 32bit registers are defined:
1- the features register (read-only, address 0x00)
This register allows the device to report features supported by the
controller.
The only feature supported for the moment is power control (0x01).
2- the command register (write-only, address 0x04)
This register allows the kernel to send the commands to the hypervisor.
The implemented commands are part of the power control feature and
are reset (1), halt (2) and panic (3).
A basic command, no-op (0), is always present and can be used to test the
register access. This command has no effect.